Dell S6000–ON - Page 689

Dell(conf)#monitor session 1 type rpm
Dell(conf-mon-sess-1)#source remote-vlan 10 dest te 1/4/1
Dell(conf-mon-sess-1)#exit
Dell(conf)#monitor session 2 type rpm
Dell(conf-mon-sess-2)#source remote-vlan 20 destination te 1/5/1
Dell(conf-mon-sess-2)#tagged destination te 1/5/1
Dell(conf-mon-sess-2)#exit
Dell(conf)#monitor session 3 type rpm
Dell(conf-mon-sess-3)#source remote-vlan 30 destination te 1/6/1
Dell(conf-mon-sess-3)#tagged destination te 1/6/1
Dell(conf-mon-sess-3)#end
Dell#
Dell#show monitor session
SessID Source Destination Dir Mode Source IP Dest IP
------ ------ ----------- --- ---- --------- --------
1 remote-vlan 10 Te 1/4/1 N/A N/A N/A N/A
2 remote-vlan 20 Te 1/5/1 N/A N/A N/A N/A
3 remote-vlan 30 Te 1/6/1 N/A N/A N/A N/A
Dell#
Configuring RSPAN Source Sessions to Avoid BPD Issues
When ever you configure an RPM source session, you must ensure the following to avoid BPDU issues:
1. Enable control plane egress acl using the following command:
mac control-plane egress-acl
2. Create an extended MAC access list and add a deny rule of (0x0180c2xxxxxx) packets using the
following commands:
mac access-list extended mac2
seq 5 deny any 01:80:c2:00:00:00 00:00:00:ff:ff:ff count
3. Apply ACL on that RPM VLAN. In this example RPM vlan is 10.
Dell#show running-config interface vlan 10
!
interface Vlan 10
no ip address
mode remote-port-mirroring
tagged Port-channel 2
mac access-group mac2 out
no shutdown
4. Create Source RPM session as follows (port-channel 1 and port-channel 2 are LACP).
Dell(conf)#monitor session 1 type rpm
Dell(conf-mon-sess-1)#source port-channel 1 destination remote-vlan 10
dir rx
Dell(conf-mon-sess-1)#no disable
5. Show the output for the LACP.
Dell#show interfaces port-channel brief
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
LAG Mode Status Uptime Ports
L1 L3 up 00:01:17 Te 1/4/1 (Up)
L2 L2 up 00:00:58 Te 1/5/1 (Up)
Dell#
Port Monitoring
689