Dell S6000–ON - Page 740

CONFIGURATION mode
Dell(conf)#buffer-stats-snapshot
Dell(conf)#no disable
Enable this utility to be able to configure the parameters for buffer statistics tracking. By default,
buffer statistics tracking is disabled.
2. Enable the buffer statistics tracking utility and enter the Buffer Statistics Snapshot configuration
mode.
CONFIGURATION mode
Dell(conf)#buffer-stats-snapshot
Dell(conf)#no disable
Enable this utility to be able to configure the parameters for buffer statistics tracking. By default,
buffer statistics tracking is disabled.
3. To view the buffer statistics tracking resource information depending on the type of buffer
information, such as device-level details, queue-based snapshots, or priority group-level snapshot in
the egress and ingress direction of traffic, use
show hardware stack-unit <id> buffer-
stats-snapshot unit <id> resource x
EXEC/EXEC Privilege mode
Dell#show hardware stack-unit 1 buffer-stats-snapshot unit 3 resource
interface all queue mcast 3
Unit 1 unit: 3 port: 1 (interface Fo 1/144)
---------------------------------------
Q# TYPE Q# TOTAL BUFFERED CELLS
---------------------------------------
MCAST 3 0
Unit 1 unit: 3 port: 5 (interface Fo 1/148)
---------------------------------------
Q# TYPE Q# TOTAL BUFFERED CELLS
---------------------------------------
MCAST 3 0
Unit 1 unit: 3 port: 9 (interface Fo 1/152)
---------------------------------------
Q# TYPE Q# TOTAL BUFFERED CELLS
---------------------------------------
MCAST 3 0
Unit 1 unit: 3 port: 13 (interface Fo 1/156)
---------------------------------------
Q# TYPE Q# TOTAL BUFFERED CELLS
---------------------------------------
MCAST 3 0
Unit 1 unit: 3 port: 17 (interface Fo 1/160)
---------------------------------------
Q# TYPE Q# TOTAL BUFFERED CELLS
---------------------------------------
MCAST 3 0
Unit 1 unit: 3 port: 21 (interface Fo 1/164)
740
Quality of Service (QoS)