Dell S6000–ON - Page 754

Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 10.11.10.0/24 via 10.11.20.2, Te 3/21/1 120/1 00:01:14
C 10.11.20.0/24 Direct, Te 3/21/1 0/0 00:01:53
C 10.11.30.0/24 Direct, Te 3/11/1 0/0 00:06:00
R 10.200.10.0/24 via 10.11.20.2, Te 3/21/1 120/1 00:01:14
R 10.300.10.0/24 via 10.11.20.2, Te 3/21/1 120/1 00:01:14
C 192.168.1.0/24 Direct, Te 3/23/1 0/0 00:06:53
C 192.168.2.0/24 Direct, Te 3/24/1 0/0 00:06:26
Core3#
The following example shows the show ip protocols command to show the RIP configuration activity
on Core 3.
Core3#show ip protocols
Routing Protocol is "RIP"
Sending updates every 30 seconds, next due in 6
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
TenGigabitEthernet 3/21/1 2 2
TenGigabitEthernet 3/11/1 2 2
TenGigabitEthernet 3/24/1 2 2
TenGigabitEthernet 3/23/1 2 2
Routing for Networks:
10.11.20.0
10.11.30.0
192.168.2.0
192.168.1.0
Routing Information Sources:
Gateway Distance Last Update
10.11.20.2 120 00:00:22
Distance: (default is 120)
Core3#
RIP Configuration Summary
Examples of Viewing RIP Configuration on Core 2 and Core 3
The following example shows viewing the RIP configuration on Core 2.
!
interface TenGigabitEthernet 2/1/1
ip address 10.11.10.1/24
no shutdown
!
interface TenGigabitEthernet 2/3/1
ip address 10.11.20.2/24
no shutdown
!
interface TenGigabitEthernet 2/4/1
ip address 10.200.10.1/24
no shutdown
!
754
Routing Information Protocol (RIP)