2. Press esc key to abort the boot process (while the system prompts to)
You enter BLI immediately, as indicated by the BOOT_USER # prompt.
press any key
3. Assign the new location of the FTOS image to be used when the system reloads.
To boot from flash partition A:
BOOT_USER # boot change primary
boot device : flash
file name : systema
BOOT_USER #
To boot from flash partition B:
BOOT_USER # boot change primary
boot device : flash
file name : systemb
BOOT_USER #
To boot from network:
BOOT_USER # boot change primary
boot device : tftp
file name : FTOS-SI-9-5-0-169.bin
Server IP address : 10.16.127.35
BOOT_USER #
4. Assign an IP address and netmask to the Management Ethernet interface.
BOOT_USER # interface management ethernet ip address ip_address_with_mask
For example, 10.16.150.106/16.
5. Assign an IP address as the default gateway for the system.
default-gateway gateway_ip_address
For example, 10.16.150.254.
6. The environment variables are auto saved.
7. Reload the system.
BOOT_USER # reload
Management
81
To Next Page
Loading...
