Delta Electronics DVP15MC11T User Manual

DVP15MC11T Operation Manual
11
1
2. Set the rotary cut technology parameters. The radius of the rotary-cut axis is 10, knife quantity
of the rotary-cut axis is 1, radius of the feed axis is 20 and cutting length of the feed axis is 30.
The start position of SYNC area is 19, end position of SYNC area is 1, and the rotary cut group
number is 1. When RotyCut_Init_Ex is TRUE, rotary cut technology parameters will be
initialized.
The variable table and program
Variable name
Data type
Initial value
RotyCut_Init
APF_RotaryCut_Init
RotyCut_Init_Ex
BOOL
TRUE
RotyCut_Init _Done
BOOL
TRUE
RotyCut_Init _Bsy
BOOL
RotyCut_Init _Err
BOOL
RotyCut_Init _ErrID
WORD
1
Axis1
True
True
Pwr1_BM
Pwr1_Bsy
Pwr1_Act
Pwr1_Err
Pwr1_ErrID
Pwr1_En
Pwr1_Sta
MC_Power
Axis Status
Pwr1
Enable
EnablePositive
Busy
Active
EnableNegative
BufferMode
Error
ErrorID
2
Axis2
True
True
Pwr2_BM
Pwr2_Bsy
Pwr2_Act
Pwr2_Err
Pwr2_ErrID
Pwr2_En
Pwr2_Sta
MC_Power
Axis Status
Pwr2
Enable
EnablePositive
Busy
Active
EnableNegative
BufferMode
Error
ErrorID
3
APF_RotaryCut_Init
Execute
RotyCut_Init
RotaryRadius
Done
Busy
Error
ErrorID
KnifeNum
FeedRadius
CutLength
SyncStartPos
SyncStopPos
RotStartPos
RotaryCutID
FedStartPos
10
RotyCut_Init_Ex
20
30
19
1
2
1
RotyCut_Init_Bsy
RotyCut_Init_Err
RotyCut_Init_ErrID
RotyCut_Init_Done
11-190

Delta Electronics DVP15MC11T Specifications

General

Brand	Delta Electronics
Model	DVP15MC11T
Category	Controller
Language	English