Delta ASDA-B2 Series - Page 171

Chapter 7 Parameters ASDA-B2
7-10 Revision May, 2018
Communication Parameter
Parameter Abbr. Function Default Unit
Control Mode
Related
Section
PT S T
P3-00 ADR Address Setting 0x7F N/A O O O 8.2
P3-01 BRT Transmission Speed 0x0203 bps O O O 8.2
P3-02 PTL Communication Protocol 6 N/A O O O 8.2
P3-03 FLT Communication Error Disposal 0 N/A O O O 8.2
P3-04 CWD Communication Time Out 0 sec O O O 8.2
P3-05 CMM Communication Mechanism 0 N/A O O O 8.2
P3-06 SDI
Control Switch of Digital Input
(DI)
0 N/A O O O 8.2
P3-07 CDT
Communication Response
Delay Time
0 1ms O O O 8.2
P3-08 MNS Monitor Mode 0000 N/A O O O 8.2
(★) Read-only register, e.g. parameter P0-00, P0-10 and P4-00, etc.
(▲)
Setting is invalid when Servo On, e.g. parameter P1-00, P1-46 and P2-33, etc.
()
Not effective until re-power on or off the servo drive, e.g. parameter P1-01 and
P3-00.
()
Volatile parameters, e.g. parameter P2-30 and P3-06.