VFD EtherNet/IP Option Card
Option Card Application Manual
64
6.3 Fault Clearing
Fault Cause Corrective Action
POWER
indicator OFF
Drive is not powered on
Check if the drive is powered on and the power
supply of the drive is normal.
CMM-EIP02 is not connected to
the drive
Check if CMM-EIP02 is tightly connected to the
drive.
LINK
indicator OFF
Network is not connected
Check if connection cable is correctly connected
to the network.
Poor contact of RJ45 connector
Check if RJ45 connector is correctly connected
to Ethernet communication port.
Option card
cannot be found
CMM-EIP02 is not connected to
network
Check if CMM-EIP02 is correctly connected to
network.
Computer and CMM-EIP02 are
not in the same network and are
blocked by network firewall
Use the assigned IP to locate or keypad to set.
CMM-EIP02
Setting page
cannot be
opened
CMM-EIP02 is not connected to
network
Check if CMM-EIP02 is correctly connected to
network.
Incorrect DCISoft
communication setting
Check if the communication of DCISoft is set to
Ethernet.
Computer and CMM-EIP02 are
not in the same network and are
blocked by network firewall
Use drive’s keypad to set
CMM-EIP02
setting page
can be opened,
but Monitor
page cannot be
used
Incorrect CMM-EIP02 network
setting
Check if the network setting of CMM-EIP02 is
correct. If it is an Intranet, contact IT personnel. If
it is a home networking, check the internet
settings provided by Internet Service Provider
(ISP).
E-Mail cannot
be sent
Incorrect CMM-EIP02 network
setting
Check if the network setting of CMM-EIP02 is
correct.
Incorrect mail server setting Check the IP address of SMTP Server.
To Next Page
Loading...
