Delta DVP-ES3 Series Hardware Manual

DVP-ES3/EX3/SV3/SX3 Series Hardware and Operation Manual
8-56
_8
Slave name
You can find the supported series name and the standard Modbus devices from the
drop-down list. If you select a supported series, devices will be used in the slave
registers. If you select a standard Modbus device or a Delta robot series, a
hexadecimal format address will be used in the slave registers.
Master register Here shows the devices used for Maser in the data exchange table.
/
: Input: the section where the master reads data from a slave.
: Output: the section where the master writes data into a slave.
Slave register Here shows the devices/addresses used for Maser in the data exchange table.
Length
Here shows the quantity of registers used in the row (the quantity varies according to
the unit).
Setting The content value of this data exchange can be set here.
Click “Setting” in the page of Modbus Data Exchange Table to open the setting page.

Delta DVP-ES3 Series Specifications

General

Brand	Delta
Model	DVP-ES3 Series
Category	Controller
Language	English