DVP-ES3/EX3/SV3/SX3 Series Hardware and Operation Manual
6-18
(2) Select Network 2, right-click Network 2, and then click
Paste
. A copy of Network 1 is put above Network
2, and Network 2 becomes Network 3.
6.5.5
Basic Editing ─ Connecting a Contact in Parallel
(1) Click on the toolbar, and then move the mouse cursor to the input contact in Network 2. The mouse
cursor changes to a contact. Move the mouse cursor to the input contact in Network 2. After the mouse
cursor changes to , click the left mouse button. This connects a contact in parallel with the input
contact in Network 2.
To Next Page
Loading...
