Denon AVR-2309CI

ENGLISH
I
[Remote Control Unit]
Symptom
Cause Countermeasure Page
Set does not work
• Batteries are worn.
• Replace with new batteries. 3
properly when • You are operating outside of the
• Operate
within the specified
3
remote control specified range.
range.
unit operated.
• Obstacle between main unit and • Remove the obstacle.
3
remote control unit
• The batteries are not inserted in
• Insert
the batteries in the 3
the proper direction, as indicated
proper direction, following the
by
the polarity marks in the
polarity marks in the battery
battery compartment compartment
• The set's remote control sensor • Move the set to a place in which 3
is exposed to strong light (direct
the remote control sensor will
sunlight, invertertypefluorescent
not be exposed to strong light
bulb light, etc.)
• The remote 10 of the main unit
• Set "Remote
10" for the main
37
and remote control unit do not
unit to "1':
match.
[Audio]
Symptom Cause
Countermeasure Page
No sound is
• You
are playing
a
monaural
• The mode is set to something
45
produced from source lTV, AM radio broadcast,
other than "STANDARD" (Dolby/
center speaker.
etc) in the "STANDARD" (Dolby/ DTS Surround).
DTS Surround) mode.
No sound • The surround mode is set to
• Set
to a
surround playback 45,46
is produced
"STEREO", "DIRECT" or "PURE mode.
from surround DIRECT".
speakers.
No sound is
• The
surround
back
speaker's
• Check the setting and change it
35
produced from
power amplifier is assigned to a as necessary.
surround back
different channel.
speaker.
• Surround back speaker setting is
• Set
to
something other than 30
set to "None".
"None".
• The
" Parameter"
- "Surround
• Please
set
"Parameter"
-
48,49
Parameter"
-
"SB
CH
Out" "Surround Parameter" -
"SB
settings are "OFF".
CH Out" to settings other than
"OFF".
• Surround mode not set to a mode
• Select
a
surround playback
44 - 46
for 6.1- or 7.1-channel playback. mode.
83
Symptom Cause Countermeasure Page
No sound is
• Subwoofer's power
not turned
• Turn on the subwoofer's power.
-
produced from on.
subwoofer.
• The
"Subwoofer"
setting at
• Set to "Yes':
29
"Speaker Configuration" is set to
"No':
• The subwoofer is
not properly
• Check the connections.
10
connected.
• The
subwoofer's volume is
• Adjust the subwoofer's
volume 63
turned off. to an appropriate level.
No test tones are
• Surround
mode not set to • Set to the "STANDARD" (Dolby/
45
produced when
"STANDARO"
(Dolby/DTS DTS Surround) mode.
main remote Surround).
control unit's
TEST button is
pressed.
OTS sound is not
• Blu-ray Disc player / DVD player's • Set the Blu-ray Disc player / OVO
-
output.
audio output setting is not set to
player. For details, refer to the
bitstream. Blu-ray Disc player / DVD player's
operating instructions.
• Blu-ray Disc player / DVD player is
• Use a DTS-compatible player.
-
not compatible with DTS sound
playback.
• The
AVR-2309CI's "Decode
• Set
to the
"Auto"
or
"DTS"
41
Mode" setting is set to "PCM ':
mode.
HDMI audio
• The "Manual Setup" - "HOMI
• Set to "AMP':
32
signals are not
Setup"
-
"HDMI
Audio
Out"
output from setting is set to "TV':
speakers.
No sound is • The "Manual Setup" - "HDMI
• Set to "TV':
32
output from Setup" - "HDMI
Audio
Out"
the monitor setting is set to "AMP':
connected
with HDMI
connections.
Dolby TrueHD,
• HDMI is not connected. • Connect the HDMI.
12,13
DTS-HD, Dolby
Digital Plus audio
is not output.