DETRUM Blitz-DT9 - Reset Model [Reset Model]

Blitz-DT9 User Manual
- 28 -
2. Roll the scroll wheel to select the channel, and then press the scroll wheel to
enter the setting interface.
Channels can be set include AIL, ELE, THR, RUD, GERA, AUX1, AUX2,
AUX3, and AUX4. You can select either mode for each channel in case of
loss of RF signal:
 Servo Hold: Maintain the servo positions as they were immediately before
the radio signal was lost.
 Fail Safe: The servos move to predefined positions in case of loss of RF
signal.
The default setting for each channel is Servo Hold. Take the aileron fail safe
setting method as an example.
AIL
1/1
1.Set：
Servo Hold
3. Change the value to Fail Safe by rolling the scroll wheel, and press the scroll
wheel to activate fail safe function
When the failsafe function is activated, the setting interface is shown in the
following figure.
AIL
1/2
1.Set：
2.Value：
Fail Safe
0
4. Set the value to desired position.
Values for each channel: -120~120. The default values for each channel are 0,
0, 0, 0, 0, 0, 0, and 0.
Reset Model [Reset Model]
This function allows you to reset all the setting of current model or all models to
default values.
Setting Method:
1. In the Model Set menu, roll the scroll wheel to select Reset Model.