DETRUM Blitz-DT9 - Elevator Curve [ELE Curve]; Throttle Curve [THR Curve]

Blitz-DT9 User Manual
- 45 -
the value is AIL-D2, you can set the aileron curve D2.
 1~9: It is used to set the value of a specific point. The servo position can be
set independently for a maximum of 9 point positions. The screen can only
display 7 points at a time. You can scroll to select other setting points by roll
the scroll wheel.
Elevator Curve [ELE Curve]
This function is used to adjust servos operation in response to elevator stick
operation. The servo position can be set independently for a maximum of 9 point
positions. There are three elevator curves D0, D1 and D2. They have the same
setting method. Take the setting of ELE Curve D0 curve as an example.
Setting Method:
1. In the Model Parameter menu, roll the scroll wheel to select ELE Curve, and
then press the scroll wheel to enter the ELE Curve D0 setting interface.
ELE Curve D0
EPA: +100
EXP: 0
LEVEL
CUSTOM
1： 0.0
2：12.5
3：25.0
4：37.5
5：50.0
7：75.0
6：62.5
ELE-D0
2. Roll the scroll wheel to select the setting item. Press and then roll the scroll
wheel to set the value of the item. After that, press the scroll wheel to save the
value.
For the descriptions of each parameter, please refer to Aileron Curve [AIL
Curve] (Page 44).
Throttle Curve [THR Curve]
This function is used to adjust throttle servo operation in response to throttle stick
operation. The servo position can be set independently for a maximum of 9 point
positions. There are three throttle curves D0, D1 and D2. They have the same
setting method. Take the setting of THR Curve D0 curve as an example.
Setting Method:
1. In the Model Parameter menu, roll the scroll wheel to select THR Curve, and
then press the scroll wheel to enter the THR Curve D0 setting interface.