DETRUM Blitz-DT9 - Veer to Elevator Mixing [Veer→ ELE MIX]

Blitz-DT9 User Manual
- 37 -
THR BAL Mix
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/1
1.Mix SW： OFF
2. Press and then roll the scroll wheel to set the value of Mix SW.
Values: OFF, ON, SA, SB, SC, SD, SE, SF, SG and SH. The default is OFF.
Change the value to ON or any other switch. Then press the scroll wheel to
activate this mixing function.
THR BAL Mix
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/4
1.Mix SW： ON
2.THR AIL：
3.THR RUD：
4.THR ELE：
0
0
0
3. Roll the scroll wheel to select the setting item. Press and then roll the scroll
wheel to set the value of the item. After that, press the scroll wheel to save the
value.
 THR→AIL: This parameter is used to set the mixing rate (percentage) from
throttle channel to aileron channel. Values: -100~100. If the value is negative,
it will adjust the aileron operation in the negative direction. If the value is
positive, it will adjust the aileron operation in the positive direction. The default
is 0.
 THR→RUD: This parameter is used to set the mixing rate (percentage) from
throttle channel to rudder channel. Values: -100~100. If the value is negative,
it will adjust the rudder operation in the negative direction. If the value is
positive, it will adjust the rudder operation in the positive direction. The default
is 0.
 THR→ELE: This parameter is used to set the mixing rate (percentage) from
throttle channel to elevator channel. Values: -100~100. If the value is negative,
it will adjust the elevator operation in the negative direction. If the value is
positive, it will adjust the elevator operation in the positive direction. The
default is 0.
Veer to Elevator Mixing [Veer→ELE Mix]
Corresponding model type: airplane, general