DETRUM Blitz-DT9 - Throttle to Balance Mixing [THR→ BAL MIX]

Blitz-DT9 User Manual
- 36 -
PgmMixA
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/1
1.Mix SW： OFF
3. Press and then roll the scroll wheel to set the value of Mix SW.
Values: OFF, ON, SA, SB, SC, SD, SE, SF, SG and SH. The default is OFF.
Change the value to ON or any other switch. Then press the scroll wheel to
activate this mixing function.
PgmMixA
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/5
1.Mix SW： ON
2.Master：
3.Slave：
4.Rate1：
5.Rate2：
AIL
AIL
+100
+100
4. Roll the scroll wheel to select the item. Press and then roll the scroll wheel to
set the value of this item. After that, press the scroll wheel to save the value.
 Master: This parameter is used to define the master channel in mixing
function. Values: AIL, ELE, THR, RUD, GEAR, AUX1, AUX2, AUX3, and
AUX4.
 Slave: This parameter is used to define the slave channel in mixing function.
Values: AIL, ELE, THR, RUD, GEAR, AUX1, AUX2, AUX3, and AUX4.
 Rate 1: This parameter is used to set the mixing rate (percentage) from
master channel to slave channel when the stick of master channel located
between the middle and top position. Values: -100~100.
 Rate 2: This parameter is used to set the mixing rate (percentage) from
master channel to slave channel when the stick of master channel located
between the middle and lowest position. Values: -100~100.
Throttle to Balance Mixing [THR→BAL Mix]
Corresponding model type: airplane, general
This function mixes the throttle operation to the aileron, rudder, and elevator.
Setting Method:
1. In the Mix Set setting interface, roll the scroll wheel to select THR→BAL Mix,
and then press the scroll wheel to enter the setting interface.