DETRUM Blitz-DT9 - Throttle Hold [THR Hold]; Swash Mixing [Swash MIX]

Blitz-DT9 User Manual
- 49 -
 ACR Fly: This parameter is used to set the control switch for acrobatic fly
function. Values: SA, SB, SC, SD, SE, SF, SG, SH and OFF. The default is
OFF.
 AIL Curve: This parameter is used to set the control switch for aileron curve
function. Values: SA, SB, SC, SD, SE, SF, SG, SH and OFF. The default is
OFF.
 ELE Curve: This parameter is used to set the control switch for elevator curve
function. Values: SA, SB, SC, SD, SE, SF, SG, SH and OFF. The default is
OFF.
 RUD Curve: This parameter is used to set the control switch for rudder curve
function. Values: SA, SB, SC, SD, SE, SF, SG, SH and OFF. The default is
OFF.
 RS Curve: This parameter is used to set the control switch for RS curve
function. Values: SA, SB, SC, SD, SE, SF, SG, SH and OFF. The default is
OFF.
 LS Curve: This parameter is used to set the control switch for LS curve
function. Values: SA, SB, SC, SD, SE, SF, SG, SH and OFF. The default is
OFF.
 R KNOB Curve: This parameter is used to set the control switch for R Knob
curve function. Values: SA, SB, SC, SD, SE, SF, SG, SH and OFF. The
default is OFF.
 L KNOB Curve: This parameter is used to set the control switch for Knob TL
curve function. Values: SA, SB, SC, SD, SE, SF, SG, SH and OFF. The
default is OFF.
Throttle Hold [THR Hold]
Please refer to Throttle Hold [THR Hold] (Page 34).
Swash Mixing [Swash Mix]
 NOTE: This function is available for helicopter only.
Using three servos to control the swash plate, the swash mixing function allows
coordinated control of the aileron, elevator, and pitch. This swash mixing is
essential for helicopters that incorporate CCPM (collective-cyclic pitch mixing)
system, and can make the swash plate setting easier.
1. In the Model Parameter menu, roll the scroll wheel to select Swash Mix, and
then press the scroll wheel to enter the setting interface.