Blitz-DT9 User Manual
- 61 -
then roll the scroll wheel to set the value. After that, press the scroll wheel to
save this value.
This parameter is used to specify the wing type of the airplane mounted with
the stabilized receiver. The value must be consistent with the actual wing type.
Otherwise the airplane cannot work properly. Values:
Normal: Normal airplane.
Delta Wing: Delta wing airplane.
V-tail: V-tail airplane.
The default is Normal.
ESC Set
This menu is specifically designed to set the programmable items of the ESC.
When working with Detrum ESC, Blitz-DT9 can set the programmable item of the
ESC without programming card. It is currently used to set programmable
parameters for the Skylord Series, Skylord Advanced Series, and Volcano Series
ESCs.
Setting Method:
1. Insert the signal wire of ESC into the transmitter ESC port as required.
2. In the Function Set menu, roll the scroll wheel to select the ESC Set. Press
the scroll wheel to wait for connecting.
Connect, Init…
Waiting, Connect…
Waiting, Power on…
>>>>>>
3. Power on the ESC. The transmitter will read the parameter of ESC and
display the programmable item. Take the Skylord ESC as an example; you
will see the interface shown as the figure below.
ESC Set
1/7
1.Brake：
2.Battery Type：
3.Cut Off Type：
4.Cut Off Voltage：
5.Start Mode：
Normal
Middle
Soft-Cut
Li-Po
OFF
To Next Page
Loading...
