DETRUM Blitz-DT9 - Model Parameter (Helicopter); End Point [End Point]; Sub Trim [Sub Trim]; Reverse [Rev Set]

- 48 -
Model Parameter (Helicopter)
Before setting the model parameters, please select the model in Model Set →
Model Select menu, and set the model type in the Select Model Type menu. If
the model is helicopter, set the model type to Helicopter.
After entering the main menu, roll the scroll wheel to select Model Parameter.
Then press the scroll wheel to enter the Model Parameter interface.
End Point [End Point]
Please refer to End Point [End Point] (Page 30).
Sub Trim [Sub Trim]
Please refer to Sub Trim [Sub Trim] (Page 31).
Reverse [Rev Set]
Please refer to Reverse [Reverse] (Page 31).
Servo Delay [Servo Delay]
Please refer to Servo Delay [Servo Delay] (Page 32).
Switch Set [Switch Set]
The switches (SA~SH) on the transmitter can be used to customize as the
control switch for acrobatic fly, aileron curve, elevator curve, rudder curve, RS/LS
curve and R/L KNOB curve.
Setting Method:
1. In Model Parameter menu, roll the scroll wheel to select the Switch Set, and
then press the scroll wheel to enter the setting interface.
Switch Set
1/8
1.ACR Fly：
OFF
2.AIL Curve：
3.ELE Curve：
4.RUD Curve：
5.RS Curve：
OFF
OFF
OFF
OFF
2. Roll the scroll wheel to select the setting item. Press and then roll the scroll
wheel to select the switch. After that, press the scroll wheel to save the value.