DETRUM Blitz-DT9 - V-Tail Mixing [V-Tail MIX]

Blitz-DT9 User Manual
- 39 -
rudder channel to elevator channel when operating the rudder stick to left.
Values: -100~100. If the value is negative, it will adjust the elevator operation
in the negative direction. If the value is positive, it will adjust the elevator
operation in the positive direction. The default is 0.
 RUD-R: This parameter is used to set the mixing rate (percentage) from
rudder channel to elevator channel when operating the rudder stick to right.
Values: -100~100. If the value is negative, it will adjust the elevator operation
in the negative direction. If the value is positive, it will adjust the elevator
operation in the positive direction. The default is 0.
V-tail Mixing [V-Tail Mix]
Corresponding model type: airplane, V-tail
V-tail mixing mixes channel 2 (ELE) to channel 4 (RUD) allowing the
ruddervators to operate both as rudders and elevators.
Setting Method:
1. In the Mix Set setting interface, roll the scroll wheel to select V-Tail Mix, and
then press the scroll wheel to enter the setting interface.
V-Tail Mix
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/1
1.Mix SW： OFF
2. Press and then roll the scroll wheel to set the value of Mix SW.
Values: OFF, ON, SA, SB, SC, SD, SE, SF, SG and SH. The default is OFF.
Change the value to ON or any other switch. Then press the scroll wheel to
activate this mixing function.
CH2 CH4
CH2 (ELE): elevator
CH4 (RUD): rudder