DETRUM Blitz-DT9 - Pitch Curve [PIT Curve]

Blitz-DT9 User Manual
- 51 -
elevator to aileron and pitch when operating the elevator stick. Values:
-100~100. If the value is negative, it will adjust the aileron and pitch operation
in the negative direction. If the value is positive, it will adjust the aileron and
pitch operation in the positive direction. The default is 100.
 PIT Mix: This parameter is used to set the mixing rate (percentage) from
aileron to aileron and elevator when operating the aileron stick. Values:
-100~100. If the value is negative, it will adjust the aileron and elevator
operation in the negative direction. If the value is positive, it will adjust the
aileron and elevator operation in the positive direction. The default is 100.
Pitch Curve [PIT Curve]
It is used to adjust pitch operation in response to throttle stick operation. The
servo position can be set independently for a maximum of 9 point positions.
There are three pitch curves D0, D1 and D2. You can set pitch curve for the HLD
(hold), NORM (normal) and ACR (acrobatic) flight modes of helicopter
respectively.
 HLD PIT Curve (Pitch Curve D0): It is used to adjust pitch operation in
response to throttle stick operation when the helicopter is in hold flight mode.
 NORM PIT Curve (Pitch Curve D1): It is used to adjust pitch operation in
response to throttle stick operation when the helicopter is in normal flight
mode.
 ACR PIT Curve (Pitch Curve D2): It is used to adjust pitch operation in
response to throttle stick operation when the helicopter is in acrobatic flight
mode.
Setting Method:
1. In the Model Parameter menu, roll the scroll wheel to select PIT Curve, and
then press the scroll wheel to enter the HLD PIT Curve setting interface.
Roll the scroll wheel to select PIT-D0 and edit this item that user can change
to the PIT Curve D1 or PIT Curve D2 setting interface.
HLD PIT Curve
EPA: +100
EXP: 0
LEVEL
CUSTOM
1： 0.0
2：12.5
3：25.0
4：37.5
5：50.0
7：75.0
6：62.5
PIT-D0
2. Roll the scroll wheel to select the setting item. Press and then roll the scroll
wheel to set the value of the item. After that, press the scroll wheel to save the
value.