Blitz-DT9 User Manual
- 50 -
Swash Mix
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1.Type： 1 Servo
2.AIL Mix：
3.ELE Mix：
4.PIT Mix：
+100
+100
+100
1/4
2. Roll the scroll wheel key to select Type. Press and then roll the scroll wheel to
set the swash type.
Values:
1 Servo: Each channel controls one servo, each servo controls one kind of
operation, without mixing. If the Type is set to 1 Servo, do not need to set
the mixing rate in step 3.
90°: This swash type is shown in the following figure. After selecting this
swash type, you can adjust the swash mixing by setting the mixing rate in
step 3.
120°: This swash type is shown in the following figure. After selecting this
swash type, you can adjust the swash mixing by setting the mixing rate in
step 3.
140°: This swash type is shown in the following figure. After selecting this
swash type, you can adjust the swash mixing by setting the mixing rate in
step 3.
The default is 1 Servo.
O (B)
A
C D
Elevator Servo
Aileron Servo Pitch Servo
90°
90° CCPM
O
A
BC D
Elevator Servo
Aileron Servo Pitch Servo
120°
120° CCPM
O
A
BC D
140°
Elevator Servo
140° CCPM
Aileron Servo
Pitch Servo
3. Roll the scroll wheel to select the mixing rate item. Press and then roll the
scroll wheel to set the value of the item. After that, press the scroll wheel to
save the value.
AIL Mix: This parameter is used to set the mixing rate (percentage) from
aileron to pitch when operating the aileron stick. Values:-100~100. If the value
is negative, it will adjust the pitch operation in the negative direction. If the
value is positive, it will adjust the pitch operation in the positive direction. The
default is 100.
ELE Mix: This parameter is used to set the mixing rate (percentage) from
To Next Page
Loading...
