DETRUM Blitz-DT9 - Rudder Curve [RUD Curve]; KNOB;L KNOB Curve]

Blitz-DT9 User Manual
- 46 -
THR Curve D0
EPA: +100
EXP: 0
LEVEL
CUSTOM
1： 0.0
2：12.5
3：25.0
4：37.5
5：50.0
7：75.0
6：62.5
THR-D0
2. Roll the scroll wheel to select the setting item. Press and then roll the scroll
wheel to set the value of the item. After that, press the scroll wheel to save the
value.
For the descriptions of each parameter, please refer to Aileron Curve [AIL
Curve] (Page 44).
Rudder Curve [RUD Curve]
This function is used to adjust servos operation in response to rudder stick
operation. The servo position can be set independently for a maximum of 9 point
positions. There are three rudder curves D0, D1 and D2. They have the same
setting method. Take the setting of RUD Curve D0 curve as an example.
Setting Method:
1. In the Model Parameter menu, roll the scroll wheel to select RUD Curve, and
then press the scroll wheel to enter the RUD Curve D0 setting interface.
RUD Curve D0
EPA: +100
EXP: 0
LEVEL
CUSTOM
1： 0.0
2：12.5
3：25.0
4：37.5
5：50.0
7：75.0
6：62.5
RUD-D0
2. Roll the scroll wheel to select the setting item. Press and then roll the scroll
wheel to set the value of the item. After that, press the scroll wheel to save the
value.
For the descriptions of each parameter, please refer to Aileron Curve [AIL
Curve] (Page 44).
RS/LS/R KNOB/L KNOB Curve [RS/LS/R KNOB/L KNOB Curve]
This function is used to adjust servos operation in response to R Wheel/L
Wheel/R KNOB/L KNOB operation. The servo position can be set independently
for a maximum of 9 point positions. There are three RS/LS/R KNOB/L KNOB