Blitz-DT9 User Manual
- 41 -
Delta (elevon) mixing mixes channel 1 (AIL) to channel 2 (ELE) allowing the
elevons to operate in unison (as elevators) or in opposition (as ailerons).
Setting Method:
1. In the Mix Set setting interface, roll the scroll wheel to select Delta Mix, and
then press the scroll wheel to enter the setting interface.
Delta Mix
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/1
1.Mix SW： OFF
2. Press and then roll the scroll wheel to set the value of Mix SW.
Values: OFF, ON, SA, SB, SC, SD, SE, SF, SG and SH. The default is OFF.
Change the value to ON or any other switch. Then press the scroll wheel to
activate this mixing function.
Delta Mix
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/5
1.Mix SW： ON
2.AIL AIL：
3.ELE AIL：
4.AIL ELE：
+100
-100
+100
5.ELE ELE： +100
3. Roll the scroll wheel to select the setting item. Press and then roll the scroll
wheel to set the value of the item. After that, press the scroll wheel to save the
value.
AIL→AIL: This parameter is used to set the mixing rate (percentage) from
aileron channel to itself. Values: -100~100. If the value is negative, it will
adjust the aileron operation in the negative direction. If the value is positive, it
will adjust the aileron operation in the positive direction. The default is 100.
CH2
CH1
CH1 (AIL): aileron
CH2 (ELE): elevator
To Next Page
Loading...
