DETRUM Blitz-DT9 - Page 45

Blitz-DT9 User Manual
- 43 -
Flaperon
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/1
1.Mix SW： OFF
2. Press and then roll the scroll wheel to set the value of Mix SW.
Values: OFF, ON, SA, SB, SC, SD, SE, SF, SG and SH. The default is OFF.
Change the value to ON or any other switch. Then press the scroll wheel to
activate this mixing function.
Flaperon
TxChs
AIL
ELE
THR
RUD
GEAR
AUX1
AUX2
AUX3
AUX4
.
.
.
.
.
.
.
.
.
1/5
1.Mix SW： ON
2.AIL AIL：
3.AIL FLP：
4.FLP AIL：
+100
-100
+100
5.FLP FLP： +100
3. Roll the scroll wheel to select the setting item. Press and then roll the scroll
wheel to set the value of the item. After that, press the scroll wheel to save the
value.
 AIL→AIL: This parameter is used to set the mixing rate (percentage) from
aileron channel to itself. Values: -100~100. If the value is negative, it will
adjust the aileron operation in the negative direction. If the value is positive, it
will adjust the aileron operation in the positive direction. The default is 100.
 AIL→FLP: This parameter is used to set the mixing rate (percentage) from
aileron channel to flap channel. Values: -100~100. If the value is negative, it
will adjust the flap operation in the negative direction. If the value is positive, it
will adjust the flap operation in the positive direction. The default is -100.
 FLP→AIL: This parameter is used to set the mixing rate (percentage) from
flap channel to aileron channel. Values: -100~100. If the value is negative, it
will adjust the aileron operation in the negative direction. If the value is
positive, it will adjust the aileron operation in the positive direction. The default
is 100.
 FLP→FLP: This parameter is used to set the mixing rate (percentage) from
flap channel to itself. Values: -100~100. If the value is negative, it will adjust
the flap operation in the negative direction. If the value is positive, it will adjust
the flap operation in the positive direction. The default is 100.
CAUTION: