DETRUM Blitz-DT9 - Page 57

Blitz-DT9 User Manual
- 55 -
Values:
 OFF: This timer is disabled. You do not need to set the following items
when OFF is selected.
 UP Timer: This timer is enabled, and displays on the main screen as up
timer.
 DOWN Timer: This timer is enabled, and displays on the main screen as
down timer.
The default is OFF.
After that, press the scroll wheel to save this value and set the next item.
3. Roll the scroll wheel to select Trigger. Press and then roll the scroll wheel to
set the value.
Values:
 Threshold: The timer will be programmed to start when the throttle is
raised above a predefined position. If the parameter Trigger is set to
Threshold, you need to set the THR Position (as shown in Step 5).
 Switch: The timer will be programmed to start by toggling the switch. If the
parameter Trigger is set to Switch, you need to set the Switch item (as
shown in Step 4).
The default is Threshold.
After that, press the scroll wheel to save this value and can set the next item.
4. Roll the scroll wheel to select Switch. Press and then roll the scroll wheel to
set the value. Values: SA, SB, SC, SD, SE, SF, SG, and SH. The default is
SF.
The timer will be programmed to start when you put the switch on top or
middle position, and pause when you put the switch on bottom position.
After that, press the scroll wheel to save this value and can set the next item.
 Note: Do not need to set this item when Trigger is set to Threshold.
5. Roll the scroll wheel to select THR Threshold. Press the then roll the scroll
wheel to set the value. Values: -100~100. The default is -90.
The timer will be programmed to start when the throttle is raised above a
predefined position, and pause when falling below this position.
After that, press the scroll wheel to save this value and can set the next item.
 Note: Do not need to set this item when the parameter Trigger is set to
Switch.
6. Roll the scroll wheel to select the Timer (min)/Timer (sec). Press and then
roll the scroll wheel to set the value. After that, press the scroll wheel to save
the value.