DETRUM GAVIN 8C - Binding; Range Test

GAVIN-8C Instruction Manual
- 14 -
9. Install the batteries and the battery cover.
 NOTE: After changing the location of throttle stick and elevator stick, please
change the stick mode. For details, please refer to Stick Mode [Stick Mode]
(Page 54).
Binding
In order for the transmitter and receiver to communicate, it is essential to pair or
bind them together. When you use the R/C system first time or change a
transmitter/receiver, this procedure is necessary. Each transmitter has an
individually assigned, unique ID code. Once the binding is made, the ID code is
stored in the receiver and no further binding is necessary after restarting the
receiver.
Preconditions:
 Move the throttle stick to the lowest position and make sure the transmitter is
powered off.
 Place the transmitter and the receiver close to each other within a distance of
about one meter.
Steps:
1. Power on RXC8 receiver. The status LED will start fast red flashing, indicating
the transmitter is off.
2. Long press (more than 2 sec) Bind/Mode button, the status LED will start
slow red flashing, indicating the receiver is in bind mode and ready to be
bound to the transmitter.
3. While pulling and holding the SC switch of transmitter, turn on the transmitter.
The system begins to bind.
4. Once the status LED on the receiver stays green, indicating the receiver is
bound to the transmitter. Release the SC switch.
5. Turn off the transmitter and receiver.
Range Test
It is extremely important to perform a range check before each flying session.
This enables you to ensure that each function is working as it should be.