DETRUM GAVIN 8C - Dual Rate (D;R) Setting

GAVIN-8C Instruction Manual
- 16 -
 You can change between normal and throttle hold flight mode by toggling
throttle hold switch. The switch can be customized, please refer to Function
Set (Page 43).
 You can change between normal and acrobatic flight mode by toggling
acrobatic flight switch. The switch can be customized, please refer to
Function Set (Page 43).
Dual Rate (D/R) setting
This function switches aileron, elevator, and rudder control surfaces between
different control surface angles and curves, using the dual rate (D/R) switches.
Setting Method:
1. Choose the switches for AIL D/R, ELE D/R, and RUD D/R functions.
The default values for AIL D/R, ELE D/R, and RUD D/R functions are SF.
Users can choose from any of the switches on the transmitter. The steps for
setting the switches are described in Function Set (Page 43).
You can select the same switch for aileron, elevator, and rudder control
surfaces, and can also select different switches for each control surface.
2. Change between D0, D1 and D2 mode by toggling the switch.
Take the following diagram as an example, toggle the switch to make AIL,
ELE, and RUD to D2 status. Then AIL Curve DR2, ELE Curve DR2, and
RUD Curve DR2 defined in Stick Curve [Stick Curve] (Page 19) will come into
effect.
. .
. .
0%
00:00
00:00
MODEL01
GAVIN-8C
NORM
00:00:57
86%
1.
2.
AIL: D2
ELE: D2
RUD: D2