- 53 -
System Set
The System Set menu sets up functions of the transmitter, does not set up any
model data.
After entering the main menu, press UP or DOWN key to select System Set, and
then press ENT key to enter the System Set interface.
Language [Language]
It is used to set the language displayed on LCD, including Chinese and English.
Setting Method:
In the System Set menu, press UP or DOWN key to select Language, and then
press R/+ or L/- key to set the language.
Calibration [Calibration]
This function calibrates the neutral position of the stick and stick travel. Stick
calibration is required in the following conditions:
Using the transmitter first time
After changing the stick mode
After upgrading the transmitter firmware
When the positions of the sticks are inconsistent with the expected results
Setting Method:
1. In the System Set menu, press UP or DOWN key to select Calibration, and
then press ENT key to enter the setting interface.
Stick Calibration
Full sticks travel
Set Neutral, Then Press ENT
2. Move both right and left sticks up and down and right to left, next set both
right and left sticks to their center position, and then press ENT key to
calibrate the sticks.
To Next Page
Loading...