DETRUM GAVIN 8C - Servo Delay [Servo Delay]

GAVIN-8C Instruction Manual
- 29 -
-100~100. If the value is negative, it will adjust the elevator operation in the
negative direction. If the value is positive, it will adjust the elevator operation
in the positive direction. The default is 0.
 AIL-R: This parameter is used to set the mixing rate (percentage) from aileron
channel to elevator channel when operating the aileron stick to right. Values:
-100~100. If the value is negative, it will adjust the elevator operation in the
negative direction. If the value is positive, it will adjust the elevator operation
in the positive direction. The default is 0.
 RUD-L: This parameter is used to set the mixing rate (percentage) from
rudder channel to elevator channel when operating the rudder stick to left.
Values: -100~100. If the value is negative, it will adjust the elevator operation
in the negative direction. If the value is positive, it will adjust the elevator
operation in the positive direction. The default is 0.
 RUD-R: This parameter is used to set the mixing rate (percentage) from
rudder channel to elevator channel when operating the rudder stick to right.
Values: -100~100. If the value is negative, it will adjust the elevator operation
in the negative direction. If the value is positive, it will adjust the elevator
operation in the positive direction. The default is 0.
Servo Delay [Servo Delay]
This function allows the user to delay input from the servos, then the servos will
change at a slower rate when changing between different flying modes.
Setting Method:
1. In the Airplane Parameter menu, press UP or DOWN key to select Servo
Delay, and then press ENT key to enter the setting interface.
Servo Delay
1/8
1. CH1：
2.CH2：
3.CH3：
4.CH4：
5.CH5：
0
0
0
0
0
2. Press UP or DOWN key to select the channel, and then press R/+ or L/- key