GAVIN-8C Instruction Manual
- 47 -
Trainer Set [Trainer Set]
This function allows two transmitters to be connected by a trainer cord to allow
dual control flight instruction. Then a skilled instructor can teach a student with fly
skills using this trainer system. The instructor transmitter should be set for trainer
operation. The trainer function makes it possible for the instructor to choose
which functions and channels are to be used for instruction.
Always check operation of each control surface before each flying session. When
using the trainer function, please check the operation of both the instructor and
student transmitters.
Setting Method:
1. Use a trainer cord (optional) to connect two transmitters, and power on the
two transmitters.
2. Set the instructor transmitter for trainer operation, and choose the channels
used for instruction.
(1) In the Model Set menu, press UP or DOWN key to select Trainer Set, and
then press ENT key to enter the setting interface.
Trainer Set
1/1
1. Trainer SW：
OFF
(2) Modify the value of Trainer SW to ON by pressing R/+ key, to set this
transmitter work as trainer operation.
The setting interface is shown in the following figure.
Trainer Set
1/9
1. Trainer SW：
ON
2.AIL：
3.ELE：
4.THR：
5.RUD： ON
ON
ON
ON
To Next Page
Loading...
