- 43 -
Function Set
The switches (SA~SF) on the transmitter can be used to customize as the control
switch for throttle hold, acrobatic flight, aileron D/R, elevator D/R, rudder D/R, or
other auxiliary functions.
Setting Method:
1. Enter the function set interface by one of the following ways.
On the main screen, press L/- key to enter the setting interface directly.
After entering the main menu, press UP or DOWN key to select Func Set,
and then press ENT key to enter the setting interface.
Func Set
1/10
1. THR Hold：
2.ACR Fly：
3.TRAINER：
4.AIL D/R：
5.ELE D/R：
OFF
SF
SF
SC
OFF
2. Press UP or DOWN key to select the function item, and then press R/+ or L/-
key to select the switch.
THR Hold: This parameter is used to set the control switch for throttle hold
function. Values: OFF, SA, SB, SC, SD, SE, and SF. The default is OFF.
ACR Fly: This parameter is used to set the control switch for acrobatic flight
function. Values: OFF, SA, SB, SC, SD, SE, and SF. The default is OFF.
TRAINER: This parameter is used to set the control switch for trainer function.
Values: OFF, SA, SB, SC, SD, SE, and SF. The default is SC.
AIL D/R: This parameter is used to set the control switch for aileron D/R
function. Values: OFF, SA, SB, SC, SD, SE, and SF. The default is SF. When
the value is set to OFF, the D/R status “AIL: D1” will display on the main
screen and AIL Curve DR1 (defined in Stick Curve [Stick Curve]) will come
into effect.
ELE D/R: This parameter is used to set the control switch for elevator D/R
function. Values: OFF, SA, SB, SC, SD, SE, and SF. The default is SF. When
To Next Page
Loading...
