DETRUM GAVIN 8C - Model Parameter (Multi-Rotor); Reverse [Rev Set]; End Point [End Point]; Sub Trim [Sub Trim]

- 42 -
Model Parameter (Multi-rotor)
Before setting the model parameters, please select the Model and Type in the
Model Set menu first. If the model is airplane, set Type to MCOPTER.
After entering the main menu, press UP or DOWN key to select Model
Parameter, and then press ENT key to enter the M-Copter Parameter interface.
M-Copter Parameter
1/6
1. Rev Set
2.End Point
3.Sub Trim
4.Stick Curve
5.THR Curve
Reverse [Rev Set]
Please refer to Reverse [Rev Set] (Page 17).
End Point [End Point]
Please refer to End Point [End Point] (Page 18).
Sub Trim [Sub Trim]
Please refer to Sub Trim [Sub Trim] (Page 18).
Stick Curve [Stick Curve]
Please refer to Stick Curve [Stick Curve] (Page 19).
Throttle Curve [THR Curve]
Please refer to Throttle Curve [THR Curve] (Page 20).
Throttle Hold [THR Hold]
Please refer to Throttle Curve [THR Curve] (Page 21).