DETRUM GAVIN 8C - Page 46

GAVIN-8C Instruction Manual
- 44 -
the value is set to OFF, the D/R status “ELE: D1” will display on the main
screen and ELE Curve DR1 (defined in Stick Curve [Stick Curve]) will come
into effect.
 RUD D/R: This parameter is used to set the control switch for rudder D/R
function. Values: OFF, SA, SB, SC, SD, SE, and SF. The default is SF. When
the value is set to OFF, the D/R status “RUD: D1” will display on the main
screen and RUD Curve DR1 (defined in Stick Curve [Stick Curve]) will come
into effect.
 GEAR: This parameter is used to set the control switch for GEAR channel
(CH5). Values: OFF, SA, SB, SC, SD, SE, and SF. The default is SA.
 AUX1: This parameter is used to set the control switch for AUX1 channel
(CH6). Values: OFF, SA, SB, SC, SD, SE, and SF. The default is SD. For
helicopter, this parameter is invalid.
 AUX2: This parameter is used to set the control switch for AUX2 channel
(CH7). Values: OFF, SA, SB, SC, SD, SE, and SF. The default is SB.
 AUX3: This parameter is used to set the control switch for AUX3 channel
(CH8). Values: OFF, SA, SB, SC, SD, SE, and SF. The default is SE.