DETRUM GAVIN 8C - Page 26

GAVIN-8C Instruction Manual
- 24 -
V-tail mixing mixes channel 2 (ELE) to channel 4 (RUD) allowing the
ruddervators to operate both as rudders and elevators.
Setting Method:
1. In the Mix Set setting interface, press UP or DOWN key to select V-tail Mix,
and then press ENT key to enter the setting interface.
V-tail Mix
1/1
1. Mix SW：
OFF
TxChs
........
AIL:0
ELE:0
THR:-100
RUD:0
GEAR:0
AUX1:0
AUX2:0
AUX3:0
2. Modify the value of Mix SW to ON by pressing R/+ key, to activate V-tail
mixing function.
The setting interface is shown in the following figure.
V-tail Mix
1/5
1. Mix SW：
2.ELE ELE：
3.RUD ELE：
4.ELE RUD：
5.RUD RUD：
ON
100
100
-100
TxChs
100
........
AIL:0
ELE:0
THR:-100
RUD:0
GEAR:0
AUX1:0
AUX2:0
AUX3:0
3. Press UP or DOWN key to select the setting item, and then press R/+ or L/-
key to set the value of the item.
 ELE▶ELE: This parameter is used to set the mixing rate (percentage) from
elevator channel to itself. Values: -100~100. If the value is negative, it will
adjust the elevator operation in the negative direction. If the value is positive,
CH2 CH4
CH2 (ELE): elevator
CH4 (RUD): rudder