DEV 2194 - Factory Network Settings; Factory SNMP Settings

User Manual DEV 2194
14  Copyright DEV Systemtechnik GmbH 2013-2017
Finally, the amplifiers provide gain control and slope (or tilt) adjustment capability.
It is not possible to make parameter adjustments locally; the adjustments are to be
performed via Web Interface (chapter 5.4.4.1) or via SNMP (chapters 5.5.4.3.9.13 &
5.5.4.3.9.15). The factory settings are:
Gain: +10.0 dB
Slope (or Tilt): 0 dB
4.3.2 Factory Network Settings
The factory network settings of the device are:
IP-Address: 192.168.0.11
Netmask: 255.255.255.0
Gateway: 192.168.0.99
For changing the network setup, please refer to chapter 5.4.7.2.1.
4.3.3 Factory SNMP Settings
The factory SNMP settings are configured as follows:
Read Community: public
Write Community: private
Local/Remote changeable via SNMP:
Additionally, the default community for all four Trap Destination IP Addresses is set
to public and all configurable traps are disabled. If an address is defined without
explicit port assignment, the standard SNMP trap port 162 is assigned implicitly.
For changing the SNMP setup, please refer to chapter 5.4.7.2.2.
There are software factory defaults for some SNMP objects, please refer to the
corresponding chapters:
 .application.controlMode chapter 5.5.4.3.1
 .application.portTable.portEntry.poEnable chapter 5.5.4.3.9.2
 .application.portTable.portEntry.poRfLimit chapter 5.5.4.3.9.6
 .application.portTable.portEntry.poBiasOnOff chapter 5.5.4.3.9.8
 .application.portTable.portEntry.poBiasLimitLo chapter 5.5.4.3.9.10
 .application.portTable.portEntry.poBiasLimitHi chapter 5.5.4.3.9.11
 .application.portTable.portEntry.poGain chapter 5.5.4.3.9.13
 .application.portTable.portEntry.poTilt chapter 5.5.4.3.9.15
 .surveillance.trapEnableMask chapter 5.5.4.4.1
 .surveillance.errorEnableMask chapter 5.5.4.4.2