User Manual DEV 2194
Copyright DEV Systemtechnik GmbH 2013-2017 15
4.4 Communication Interface Configuration
The Ethernet interface is used for the operation via Web Interface or via SNMP.
4.4.1 Ethernet Interface
The connector labeled "Ethernet" is an RJ-45 jack for the standard 100Base-TX
Ethernet interface; chapter 7 describes the pin assignment.
4.4.1.1 Ethernet Connection
If a standalone device is to be connected to a PC only, the connection can be
established via a direct Ethernet cable (or through a local hub/switch) between the
Ethernet connector of the device and the Ethernet connector of the PC. The net-
work setup of the PC is to be altered that it is in the same subnet as the device. If it
is intended to use the factory network settings, the IP address of the standalone PC
is to be set to 192.168.0.x, with x in the range 1…254, except 11, which is the address of
the device, e.g. set the IP address of the standalone PC to the default gateway
address 192.168.0.99.
If the device is to be connected to the local network, make sure to change the
network setup as required. Ask your network administrator for the details on
network parameters which are to be used.
The factory network settings are subject of chapter 4.3.2.
The network setup can be changed via Web Interface (please refer to chapter
5.4.7.2.1).
4.5 Maintenance of the Product
The product is maintenance-free.
Cleaning of the surface of the chassis should be done carefully with a dry lint-free
cloth.
To Next Page
Loading...