To Next Page

To Previous Page

Drain Valve Cleaning

Step 1: Loosen the clamp on the tub hose at the drain valve end and remove the hose from

the drain valve.

Step 2: Loosen the drain hose clamp on the back of the drain valve. Remove two drain valve

mounting bracket screws from the frame of the washer.

Step 3: Remove the drain valve and bracket assembly. Unplug the wiring after the drain valve

is removed from the washer.

Masking Ring (door lock cover) Removal

Step 1: Remove front panel.

Step 2: Remove 4 nuts (3/8” socket) that retain masking ring.

Step 3: Move it to the left and off.

Detergent Dispenser (T-300, T-400, T-600, T-900)

Remove top panel to access dispenser. (see Removing Top Panel) Detergent is ﬂ ushed from

the front of the compartment and fabric softener is ﬂ ushed from the back. There will be a small

amount of water left in the fabric softener compartment after each use. This is normal. (T-1200)

Dispenser mounted on front panel. Left compartment ﬂ ushes detergent and right compartment

ﬂ ushes fabric softener.

Vacuum Breaker (also called an air gap)

In the left rear of the cabinet is the vacuum breaker. It guides the water to the tub and

dispenser and prevents a back ﬂ ow of water.

Water Valves

Remove top panel to access water valves. (see Removing Top Panel) The two dual outlet

water valves are mounted to the rear channel with two screws each. Always check inlet

screens to be sure that they are clean. Disassembly requires the removal of two solenoid

screws and three valve body screws. Below the solenoid coil is a solenoid guide, armature,

armature spring and diaphragm. All valve parts are available individually or as a complete unit.

Machine Service Procedures

Dexter Laundry A Series Service Procedures And Parts Data

Other manuals for Dexter Laundry A Series