Step 1: To remove the tub
back assembly, the 6 bolts
attaching it to the bearing
housing must be removed.
Step 2: Remove water seals
from the seal mounting plate
on the cylinder shaft. These
are removed with your fi ngers.
Removal of Bearing Housing From Basket Shaft, Bearings and Water Seals
Step 3: The retaining ring next
to the front bearing must also be
removed.
Step 4: The bearings are
pressed into the housing and
must be pressed back out.
Step 1: Make sure that the tolerance ring is in place inside the pulley.
Step 2: The shoulder inside the pulley that holds the tolerance ring should face the back of
the washer when installed correctly.
Step 3: Use a stack of fl at washers and a longer bolt to press the pulley onto the basket shaft.
Step 4: Reinstall the retaining bolt, lock washer and fl at washer. The shaft end bolt with
washer should be installed with a torque value listed in charts in this manual.
Machine Service Procedures
Basket Pulley, Bearing Housing,
Water Seals and Tub Back
The cast iron basket pulley is retained by a bolt, locking washer and a fl at washer.
Removal
Step 1: Insert a large screw driver or punch through a spoke
in the pulley into the bearing housing support. This keeps the
pulley from turning.
Step 2: Remove the retaining bolt, lockwasher and fl at washer
and reinstall just the bolt
Step 3: Use a puller to remove the pulley from the shaft. Watch
for tolerance ring.
Reassembly
51
To Next Page
Loading...
Need help?
General
