Machine Service Procedures
Loading Door Disassembly
Step 1: Remove the loading
door as outlined above. Lay the
door on a fl at surface with the
glass down
Step 2: While holding down on
the door glass, lift up on the door
ring and roll back the lip of the
gasket with your fi ngers.
Step 3: Work all the way around
the gasket and the glass is out.
FPO
Loading Door Reassembly
Step 1: Lay the door ring face
down on a fl at surface.
Start the glass into one side of
the door gasket.
Step 2: Use one hand
underneath to push the gasket
out and the other hand on the
top pulling the gasket in place
Step 3: The front lip of the door
gasket should be checked for
proper seating.
47
Control Panel Name Plate Decal
The name plate on washer front is adhesive backed.
Control Panel Name Plate Removal
The name plate may be removed by simply peeling it off.
Re-Installation of Name Plate
Step 1: Remove any remaining glue from the control panel.
Step 2: Before removing the paper backing from the name plate, check fi t to the control
panel. The program push buttons are the locating guides.
Step 3: Remove the paper backing from the right side of the name plate, position it on the
panel and press right end into place. Peel the backing from the left end and press into place.