OPERATOR’S MANUAL
GAC® 2100 Grain Analysis Computer (Blue, Gray, Agri Models)
11001-1688-201609
MEASURE MOISTURE 21
Figure 15
Basic Moisture Measuring Cycle
7. The grain name, moisture, sample ID and grain calibration issue date
appears on the display along with the sample temperature and test
weight, if enabled.
8. The option <more> displays on the lower right corner of the screen.
9. Press the Next Page key to view additional pages. The D1 through D4
values display along with the present date (lower left corner) and time
(lower right corner).
10. Blue model-If the <more> prompt continues to display, press the Next
Page key again.
– This page is only available if FACTORS are used. FACTORS are a
type of label that allows entry of data for additional information on
the paper printout. Up to four user-defined factors (or labels) may
display and print as specified on the Setup menu. If this screen
displays, enter numbers as desired and select the Enter key. If no
factor names are specified, the screen will not display.
11. When the measurement is complete, select the Unload key. The test
cell will invert dumping the grain and returning to the upright position.
12. Start a new moisture measurement for the same grain type. The
GAC 2100 remembers the grain type until it is changed or power is
turned OFF. The Select Grain menu does not appear again until it is
selected.
PLEASE WAIT
MEASURING
WHEAT HRW
960918
ID: AD38
PRESS LOAD TO BEGIN
FILL SAMPLE HOPPER, ENTER ID NO. THEN
WHEAT HRW
ID:AD1234
960918
MOISTURE
13.4%
WHEAT HRW
TEMP: 30 C
ID: AD38 <more>
960918
Press
the
Load Key
PLEASE WAIT
PERFORMING SELF CHECKS
WHEAT HRW
960918
Press
the
Dump Key
Next Page Key
Enter Key
Unload Key
To Next Page
Loading...
Need help?
General
