OPERATOR’S MANUAL
GAC® 2100 Grain Analysis Computer (Blue, Gray, Agri Models)
11001-1688-201609
46 INSTRUMENT SETUP
CHANGE DATE, TIME, AND DATE FORMAT (5
KEY)
This function establishes correct date and time for display and print out with
each grain moisture measurement.
To Set the Time:
1. From the Setup menu, select the Date/Time menu (5 key). Three
options are available; (1) SET TIME, (2) SET DATE and (3) SET DATE
FORMAT (Figure 36).
2. From the Date/Time menu, select SET TIME using the 1 key. The Set
Time screen appears and displays ENTER ACCESS CODE.
3. Enter the access code and select the Enter key. The time displays
based upon a 24-hour clock.
4. Change the time by entering new numbers from the keyboard. The
time format is in hours, minutes, seconds (HH.MM.SS). Each unit is
two digits and is separated by a decimal point.
– For example, to enter 3:32:59 P.M., enter 15.32.59. Use decimal
points to separate units. If accuracy is desired, set the time slightly
ahead and wait. At the exact time, press the Enter key to start the
clock.
5. Press Previous Page to exit.
Figure 36
Setting The Time
DATE/TIME MENU
1: SET TIME
2: SET DATE
3: SET DATE FORMAT
SELECT ITEM NUMBER
(NEXT PAGE: STATUS)
SET TIME
ENTER ACCESS CODE: __
SET TIME
CURRENT TIME IS 02 : 21 : 40
ENTER NEW TIME (HH. MM. SS) :
Enter Key
Previous Page Key
To Next Page
Loading...
Need help?
General
