- 16 -
DI-80 USER MANUAL
1.6 NET/GROSS OPERATION
Gross weight displays are available in both Weighing Mode and Counting Mode. In Weighing Mode, allow user use numeric key
and [PRINT] key to perform printing operation. PLU are not allowed to call up in Gross Mode, but allow call up in NET mode
and then switch to Gross Mode. In Counting Mode, This key is used to view the Gross Weight for the item only and all numeric
keys and [PRINT] key are disabled.
Note: To enable this operation, SPEC 25 bit 0 must set to "0" in advance.
OPERATION KEY DISPLAY
NET
kg
0. 5 0 0
T
1. At Weighing Mode, place
500g of weight on the platter.
¼T» NET
kg
0. 0 0 0
T
2. Press [T] key to subtract the
tare weight.
¼T» NET
kg
0. 5 0 0
T
3. Place another 500g of weight
on the platter.
B/G
¼T» NET
kg
1. 0 0 0
T
T
4. Press [NET/ B/G] key to
enter GROSS Mode.
Press [¾
] key if you want to
issue a receipt or press [+] / [-]
key for Accumulation /
Subtraction operation.
¼T» NET
kg
0. 5 0 0
T
5. Back to NET Mode, press
[NET/ B/G] key again.
To Next Page
Loading...
Need help?
General
