Interfaces Local Area Networks (LANs)
IX14 User Guide
141
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure DHCP options
You can configure DHCP servers running on your IX14 device to send certain specified DHCP options to
DHCP clients. You can also set the user class, which enables you to specify which specific DHCP clients
will receive the option. You can also force the command to be sent to the clients.
DHCP options can be set on a per-LAN basis, or can be set for all LANs. A total of 32 DHCP options can
be configured.
Required configuration items
n
DHCPoption number.
n
Value for the DHCP option.
Additional configuration items
n
The data type of the value.
n
Force the option to be sent to the DHCPclients.
n
A label for the custom option.
WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click to expand an existing LAN, or create a new LAN. See Configure a LAN.
To Next Page
Loading...
Need help?
General
