System administration Erase device configuration and reset to factory defaults
IX14 User Guide
293
WebUI
1. Log into the IX14 WebUI as a user with Admin access.
2. On the main menu, click System. Under Configuration, click Configuration Maintenance.
The Configuration Maintenance windows is displayed.
3. In the Erase configuration section, click ERASE.
4. Click CONFIRM.
5. After resetting the device:
a. Connect to the IX14 by using the serial port or by using an Ethernet cable to connect the
IX14 LAN port to your PC.
b. Log into the IX14:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
Note If your device was manufactured prior to the release of firmware version 19.11.x, the
default user name may be root.
c. (Optional) Reset the default password for the admin account. See Change the default
password for the admin user for further information.
Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
To Next Page
Loading...
Need help?
General
