System administration Erase device configuration and reset to factory defaults
IX14 User Guide
294
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the IX14 by using the serial port or by using an Ethernet cable to connect the
IX14 LAN port to your PC.
b. Log into the IX14:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
Note If your device was manufactured prior to the release of firmware version 19.11.x, the
default user name may be root.
c. (Optional) Reset the default password for the admin account. See Change the default
password for the admin user for further information.
Reset the device by using the RESET button.
1. Locate the RESET button on your device.
2. Press the RESET button perform a device reset. The RESET button has the following modes:
n
Configuration reset:
l
Press and release the RESET button .
l
The device reboots automatically and resets to factory defaults. This does not
remove any automatically generated certificates and keys.
n
Full device reset:
l
After the device reboots from the first button press, immediately press and release
the RESET button again.
l
The device reboots again and resets to factory defaults, as well as also removing
generated certificates and keys.
n
Firmware reversion: Press and hold the RESET button and then power on the device
to boot to the version of firmware that was used prior to the current version.
3. After resetting the device:
a. Connect to the IX14 by using the serial port or by using an Ethernet cable to connect the
IX14 LAN port to your PC.
b. Log into the IX14:
User name: Use the default user name: admin.
To Next Page
Loading...
Need help?
General
