Digi IX14 User Manual

Services Allow remote access for web administration and SSH
IX14 User Guide
318
4. For Add Zone, click .
5. Select External.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the external zone to the web administration service:
(config)> add service web_admin acl zone end external
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Add the External firewall zone to the SSH service

Digi IX14 Specifications

General

Brand	Digi
Model	IX14
Category	Network Router
Language	English