Digi IX14 User Manual

Services Location information
IX14 User Guide
371
9. For Forward interval multiplier, select the number of Location update intervals to wait
before forwarding location data to this server. See Configure the location service for more
information about setting the Location update interval.
10. For NMEA filters, select the filters that represent the types of messages that will be forwarded.
By default, all message types are forwarded.
n
To remove a filter:
a. Click the down arrow () next to the appropriate message type.
b. Click Delete.
n
To add a message type:
a. For Add NMEAfilter or Add TAIP filter, click .
b. Select the filter type. Allowed values are:
l
GGA: Reports time, position, and fix related data.
l
GLL: Reports position data: position fix, time of position fix, and status.
l
GSA: Reports GPS DOP and active satellites.
l
GSV: Reports the number of SVs in view, PRN, elevation, azimuth, and SNR.
l
RMC: Reports position, velocity, and time.
l
VTG: Reports direction and speed over ground.
11. For TAIP filters, select the filters that represent the types of messages that will be forwarded.
By default, all message types are forwarded.
n
To remove a filter:
a. Click the down arrow () next to the appropriate message type.
b. Click Delete.
n
To add a message type:
a. For Add NMEAfilter or Add TAIP filter, click .
b. Select the filter type. Allowed values are:
l
AL: Reports altitude and vertical velocity.
l
CP: Compact position: reports time, latitude, and longitude.
l
ID: Reports the vehicle ID.
l
LN: Long navigation: reports the latitude, longitude, and altitude, the horizontal
and vertical speed, and heading.
l
PV: Position/velocity: reports the latitude, longitude, and heading.
12. For Outgoing message type, select either NMEAor TAIP for the type of message that the
device will forward to a remote host.
n
(Optional) If NMEA is selected, select a Talker ID.
The talker IDis a two-character prefix in the NMEAmessage that identifies the source
type. The talker ID set here will override the talker ID from all sources, and all
forwarded sentences will use the configured ID. The default setting is Default, which
means that the talker ID provided by the source will be used.
13. (Optional) For Prepend text, enter text to prepend to the forwarded message. Two variables
can be included in the prepended text:

Digi IX14 Specifications

General

Brand	Digi
Model	IX14
Category	Network Router
Language	English