Revision history—90002291
IX14 User Guide
5
Revision Date Description
the local date and time.
n
New firewall packet filter options to allow/deny
packets based off of a range of source or destination
MAC addresses.
n
New monitoring metrics upload CLI command to
send on-demand health metrics to Digi Remote
Manager.
n
Added support for the configuration of custom scripts
that will be run manually, and a new system script
start CLI command to run manual scripts.
n
New "Find me" feature that flashes cellular-related
LEDs to help locate the device onsite and a new
system find-me command.
n
Added datapoint.upload_multiple function to
digidevice python module for uploading multiple
datapoints to DigiRM at once.
n
Added clear dhcp-lease command to remove all
dynamic DHCP leases or certain DHCP leases based on
MAC address or IP address.
n
Added speedtest command for performing on-demand
iPerf or nuttcp speedtests.
n
Local users are now required to be assigned to an
authentication group.
n
New Network → Advanced → Sequential DHCP address
allocation configuration setting for controlling if DHCP
addresses are assigned sequentially or randomly
(disabled by default).
n
Added ability to control if DHCP addresses are assigned
sequentially or randomly (disabled by default).
n
Added 802.1x port-based network access control,
configurable per network interface.
L December 2021
Release of Digi IX14 firmware version 21.11:
n
Configuration option to allow for automatic update of
new firmware (disabled by default).
n
User authentication enhancements:
l
Added TACACS+ command authorization and
accounting for Admin CLI commands.
l
Added a new username alias to provide an
alternate username that allows for special
characters in the username.
n
VPNenhancements:
l
Added support for PPP-over-L2TP tunnels.
To Next Page
Loading...
Need help?
General
