Digi IX14

Interfaces Wireless Wide Area Networks (WWANs)
IX14 User Guide
73
Note If the reboot parameter is enabled at the same time as either the restart or reset_
modem parameters, the reboot parameter takes precedence.
n
(Optional) Set the number of times that the Surelink test must fail before the device is
rebooted:
(config network interface my_wwan ipv4 surelink)> reboot_attempts
int
(config network interface my_wwan ipv4 surelink>
where int is any number greater than 0. The default is 1.
9. Add a test target:
(config network interface my_wwan)> add ipv4 surelink target end
(config network interface my_wwan ipv4 surelink target 0)>
10. Set the test type:
(config network interface my_wwan ipv4 surelink target 0)> test value
(config network interface my_wwan ipv4 surelink target 0)>
where value is one of:
n
ping: Tests connectivity by sending an ICMP echo request to a specified hostname or IP
address.
l
Specify the hostname or IP address:
(config network interface my_wwan ipv4 surelink target 0)> ping_
host host
(config network interface my_wwan ipv4 surelink target 0)>
l
(Optional) Set the size, in bytes, of the ping packet:
(config network interface my_wwan ipv4 surelink target 0)> ping_
size [num]
(config network interface my_wwan ipv4 surelink target 0)>
n
dns: Tests connectivity by sending a DNS query to the specified DNS server.
l
Specify the DNS server. Allowed value is the IP address of the DNS server.
(config network interface my_wwan ipv4 surelink target 0)> dns_
server ip_address
(config network interface my_wwan ipv4 surelink target 0)>
n
dns_configured: Tests connectivity by sending a DNS query to the DNS servers
configured for this interface.
n
http: Tests connectivity by sending an HTTP or HTTPS GET request to the specified URL.
l
Specify the url: