Appendix B: Utility Mode 115
Display Test Page
The Display tests let you test the LCD displays
and the Main Counter on C|24.
To test the LCD displays:
From the Display Test page, press the encoder
switch that corresponds to one of the following:
• ASCII Set: Shows the entire ASCII character
set at once.
• ASCII Step: Cycles through the ASCII char-
acter set on each LCD segment.
To test the Main Counter:
From the Display Test page, press the encoder
switch that corresponds to “Timecode.”
The Main Counter cycles through 0-9 and the
Time Display Format Indicators light.
To exit a Display test:
Press the encoder switch that corresponds to
“Exit.”
Fader Test Page
The Fader tests let you test and recalibrate the
C}24 faders.
To test the faders:
From the Fader Test page, press the encoder
switch that corresponds to any of the following:
Step Faders move together, in stepped fashion,
to positions that are adjustable with the
Scrub/Shuttle wheel. Fader position values are
shown in the LCD displays (0-1023).
Cycle Faders move together, from the bottom to
top, in a continuous cycle, at a speed that is ad-
justable with the Scrub/Shuttle wheel. Fader po-
sition values are shown in the LCD displays
(0-1023).
Group Faders can be moved to test group re-
sponse. Fader position values are shown in the
LCD displays (0-1023). This test shows which
faders are currently being touched by displaying
the letter “T” in the LCD displays above the fad-
ers.
Touch Each fader can be touched to show touch
sensitivity. The LCD displays show the fre-
quency that the fader is currently recognizing.
This test shows which faders are currently being
touched by displaying the letter “T” in the LCD
displays above the faders.
To exit a Fader test:
Press the encoder switch that corresponds to
“Exit.”
Recalibrating the Faders
The Recalibrate command recalibrates the touch
sensitivity and position of all faders to factory
specifications.
To recalibrate the faders:
From the Fader Test page, press the encoder
switch that corresponds to “Recalibrate.”
Rotary Test Page
The Rotary test lets you test the C}24 rotary en-
coders that have LED rings (the 24 channel ro-
tary encoders and the Control Room encoder).
The Rotary test shows two values:
• Delta: Shows the direction and speed an in-
dividual encoder is being turned.
• Cumulative: Shows the number of steps
that all of the encoders have been turned
during the text.
To test the rotary encoders:
From the Rotary Test page, turn any encoder.
To Next Page
Loading...
