DigiDesign C24 User Manual

C|24 Guide120
Resetting Monitor Gain Settings
This page lets you reset gain and trim levels in
the C|24 monitor section (set with the Control
Room rotary encoder) to their default values.
To reset monitor gain levels and trim offsets:
1 Press the Utility switch.
2 Press the encoder switch that corresponds to
“System.”
3 Hold the encoder switch that corresponds to
“Reset Monitor Gains.”
4 Do one of the following:
• To confirm the reset, press the encoder
switch that corresponds to “OK.”
– or –
• To cancel the reset, press the encoder
switch that corresponds to “Cancel.”
5 When you are finished, press the encoder
switch that corresponds to “Exit.”
Auto Talkback
Auto Talkback is a setting that automatically
turns on the Talkback and Listen microphones
when the Pro Tools Transport is stopped, and
turns the Talkback and Listen microphones off
when the Pro Tools Transport is running.
To activate Auto Talkback:
1 Press the Utility switch.
2 Press the encoder switch that corresponds to
“Auto Talkback” to toggle the Auto Talk option
On and Off.
3 When you are finished, press the encoder
switch that corresponds to “Exit.”

DigiDesign C24 Specifications

General

Type	Control Surface
Channels	24
Compatibility	Pro Tools
Faders	24 motorized
Inputs	8 analog line inputs
Outputs	8 analog line outputs
Aux Sends	N/A (Control surface only)
Connectivity	Ethernet, MIDI
Display	LCD scribble strips
Power Supply	External power supply